The largest milled propeller to date

Lykkegaard has just had a new Okuma CNC lathe with milling function installed at the factory. Among other things, it will be used to turn items such as pump housings, axle equipment and pump hubs, which will be used for the propeller pumps that are produced at the factory in Ferritslev. Some of the advantages are, that it can make work more efficient, increase accuracy and improve the working environment.

Did you know that 99% of a pump from Lykkegaard A/S can be reused or recycled? And that we offer to disassemble old pumps and sort the parts so that they can be reused as best as possible? This is how we have always done it - but now it has become modern to relate to reuse and recycling.

Large pumpe testet af Lykkegaard's test centre. 600 mm and 1100 litres/sec at 5 mtr.

Quick repair was made possible by reusing a used pump part from an old pump

Two French pumps from fish farming have been restored after 20 years of uninterrupted pump work

New milled propellers are more exact than the former casted types. This makes the pumps even more energy efficient. The new propellers

Lykkegaard has repaired and restored one pump for Odense Harbour's large dry dock. So now the dock can once again function at full power

Lykkegaard is sending five propeller pumps for a french aquaculture setting. They are alle tested before leaving the factory in Denmark. In thhis way we can assure the customer that they comply with the specifications